The calculation of the maximum SPL based on power characteristics of the amplifier
Link to this page with the selected parameters
Max. voltage level no load
mA, maximum output current
ohm, output impedance of the amplifier
Headphone sensitivity - dB/V
ohm, Headphones impedance
Average RMS Power for the music signal
Peak factor in the unevenness of the music volume
dBFS (the volume level in the player or DAC)
Calculate
The value of the SPL with the level in dBFS for a saturated parcel of the composition
The average music signal of RMS: - dB SPL (Slow)
The volume level taking into account the unevenness for the music signal: - dB SPL
Peak level - dB SPL
Sufficient power for reproduction without distortion
-
Maximum SPL without overloading (large distortion) the amplifier and for recording the level in dBFS
For a sinusoidal signal:
- dB SPL (Slow)
The average music signal of RMS - dB SPL (Slow)
Additional values and analysis
Specified maximum current at the amplifier output: - dB(mA), - mA
The signal level at the output of the amplifier with the setting of the lower level: - dBV, - VRMS где
-
- voltage drop depending on the impedance of the headphones and amplifier
-
- lowering the level of the volume control
Требуемый ток на нагрузке - Ом при напряжении - dBV:
- dB(mA), - mA
- без учета плотности музыкального сигнала
- dB(mA), - mA
- с учетом плотности музыкального сигнала ( - dB)
The calculator allows you to calculate the maximum sound pressure levels of headphones based on
performance of the amplifier and of the main parameters headphones.
The main parameters are from the report measurement of headphones and headphone amplifiers, or passport from manufacturers.
The default for a musical signal, the value of the energy density is set to -12 dB
The level in dBFS for DACs, music players and sound cards you enter negative numbers: -6, -12,
etc.