Test report - general data of Topping D70 MODE 2 as Line Out mode
General results Topping D70 MODE 2
Summary (Right + Left)
Variation in frequency response in band from 100 Hz to 10 kHz, dB
Max voltage output at 0 dBFS, VRMS
Max voltage output at 0 dBFS, dBV
Max voltage output at 0 dBFS, dBu
Harmonic distortion at 0,0 dBFS @ 1 kHz, dB
Total harmonic distortion at 0,0 dBFS @ 1 kHz, %
Harmonic distortion at -3,0 dBFS @ 1 kHz, dB
Total harmonic distortion at -3,0 dBFS @ 1 kHz, %
The table shows a most important technical characteristics of Topping D70 MODE 2
*Center channel headphone is received by averaging between left and right channels
- Measured by RAA with ADC from E-MU1616m
- Difference ... 0 dBFS out level Topping D70 MODE 2 versus ADC E-MU1616m 0 dBFS input level is -12,51 dB (value level for left and right channels)
- During tests RAA measuring complex was used galvanic isolated power transformer and was excluded the effect of ground loop in the spectra
Spectra of high resolution
Spectra vs Amplitude
Measurements of Topping D70 MODE 2 were carried out by Roman Kuznetsov on the hardware-software complex RAA.
The Topping D70 MODE 2 test was conducted as a black box test, without regard to cost and prestige. This is the basic principle for making measurements, measurement reports and developing tests in RAA.
Founder of RAA
Known by the nickname romanrex
Аuthor of articles iXBT.com
Information for Authors. You can freely use the graphics in your articles with a link to us.
Topping D70 is available in reports and services. You are in a professional report.