During tests RAA software-hardware measuring complex was used galvanic isolated power transformer and was excluded the effect of ground loop in the spectra
Frequency response of E-MU 1616m Ref B6 as AMP mode
Graphics setting view
Range, dB:
Channel:
Table of measured characteristics
Frequency response E-MU 1616m Ref B6
Channel
Left
Right
Variation in frequency response in band from 100 Hz to 10 kHz, dB
-0,03, 0,01
-0,05, 0,01
Crosstalk of E-MU 1616m Ref B6 as AMP mode
Graphics setting view
Range, dB:
Channel:
Table of measured characteristics
THD vs load vs output voltage of E-MU 1616m Ref B6 as AMP mode
Graphics setting view
Channel:
Type test:
Table of measured characteristics
Spectrum of Total Harmonic Distortion vs Level of E-MU 1616m Ref B6 as AMP mode
Not loaded
Graphics setting view
Channel:
Level, dBV:
Spectrum of IMD SMPTE vs Level of E-MU 1616m Ref B6 as AMP mode
Not loaded
Graphics setting view
Frequency band, Hz:
Channel:
Level, dBV:
Spectrum of IMD CCIF vs Level of E-MU 1616m Ref B6 as AMP mode
Not loaded
Graphics setting view
Channel:
Level, dBV:
Spectrum of Multitone Distortion vs Level vs Load of E-MU 1616m Ref B6 as AMP mode
Not loaded
Graphics setting view
Channel:
Level, dBV:
Type test:
Spectrum of Noise Distortion vs Level vs Load of E-MU 1616m Ref B6 as AMP mode
Measurements of E-MU 1616m Ref B6 were carried out by Roman Kuznetsov on the hardware-software complex RAA.
The E-MU 1616m Ref B6 test was conducted as a black box test, without regard to cost and prestige. This is the basic principle for making measurements, measurement reports and developing tests in RAA.
Kuznetsov Roman Founder of RAA
Known by the nickname romanrex Аuthor of articles iXBT.com
Information for Authors. You can freely use the graphics in your articles with a link to us.
E-MU 1616m Ref B6 is available in reports and services. You are in a professional report.
