After testing in the benchmark mode in the Reference Audio Analyzer software, the data is added to the online database of the RAA website.
You can view the test results on the comparison pages
and summary reports for beginners
and professionals.
You can go to the desired report or comparison/selection service through the menu on this page. Additionally, you can go to the comparison pages from any graph from reports and add other tested products for direct comparison.
Abyss AB1266 is available in reports and services. You are on the title page of the reports and services.
Information for entry level users
Information for all
Versus of characteristics
Information for professionals
Comparison of on-line graphs
- Comparison the frequency response
- Impedance
- Electric phase
- QSD / Watterfall
- Comparison of the frequency response/SPL of the bundles of headphones and amplifiers
- Voltage and Sensitivity
- SPL from bundle
- Impulse, Envelope, Step responses and Square wave
- Selection of headphones for the target frequency response
- Export Frequency response
More detailed
Measurements of Abyss AB1266 were carried out by Roman Kuznetsov on the hardware-software complex RAA.
The Abyss AB1266 test was conducted as a black box test, without regard to cost and prestige. This is the basic principle for making measurements, measurement reports and developing tests in RAA.
I believe that it is important to do not make an absolute assessment of the device, but an aggregate assessment when working together with a source amplifier and taking into account external factors. This allows you to effectively reveal the potential of the entire set of devices or to make a more optimal choice of components.
Kuznetsov Roman
Founder of RAA
Information for Authors. You can freely use the graphics in your articles with a link to us.
Ввожу в форму данные по чувствительности по мощности 83.48 дБ/мВт SPL, сопротивления 45 Ом, выходное сопротивление усилителя для наушников 0.3 Ом. Ввожу различные значения напряжения Vrms на выходе. То что получается в результате не совпадает с данными на этой странице. Уже при 10 Vrms развиваемое звуковое давление ~117dB SPL (я так понимаю это пиковое значение громкости).
Или же на этой странице указаны значения 90 dB SPL и 105 db SPL - как среднее значение громкости?